Galvanized Pipe To Copper Transition

Wrap threads on end of the steel pipe with teflon tape.

Galvanized pipe to copper transition.

Benefits of galvanized pipes. Use two pipe wrenches to loosen the old union. The problem with galvanized pipe is that it reacts with the minerals in the water supply. So try to make the transition at an existing female fitting.

It might be a transition from threaded galvanized water pipes to copper pipes or from old cast iron sewer lines to today s abs. Tighten first with pliers then with pipe wrench. You don t need to wrap plumbing tape around the union before you screw it together. If the surface of the pipe is the color of a penny then the pipe is probably made from copper.

Galvanized steel pipes on the other hand are a steel gray color. Find the area where pipes enter your home and carefully scratch the pipe with a nickel. This eventually causes pipe degradation and leakage. The inside of galvanized pipes gets thinner over the years.

This fitting joins a copper pipe to a galvanized pipe called a union. Remove the old union from the steel pipe. Install the lower half of the dielectric union to steel pipe. It s far easier to make a repair to steel pipe with copper than with galvanized plumbing pipe because the galvanized calls for cutting threads on exact lengths of pipe.

Since brass doesn t react with either the copper or the zinc one method is to make sure you have a threaded female end on both the copper and the steel pipes and then connect the two by simply inserting a short threaded brass nipple between them the second method is to use a special transition fitting called a dielectric union. The reaction creates scale which will eventually clog the pipe. Solder the brass half to the copper pipe thread the steel half onto the galvanized steel pipe with teflon tape then join the two together tightly with the joining nut. If the copper and galvanized pipes aren t the same diameter solder a reducing coupling to the copper pipe.

The fitting is generally made of galvanized steel and bronze. Cut copper pipe just above the corroded connection using a tubing cutter. Plastic pipes are usually black and clamps should be visible. When water flows through pipes of two different metals the pipes will become eroded by electrical impulses from the slight acidity found in all water sources.